Denon amplifier two speakers
Top sales list denon amplifier two speakers
Pakistan (All cities)
Product details of PAM8610 15W + 15W Two Channel Stereo Class D Amplifier Board Supply voltage: DC 7V-15V 2. Output power: 10w + 10w (8 load) 3. Efficiency: 90% 4. Shutdown Current: 4uA 5. Quiescent current; 20mA 6. SNR: 86% 7. Total harmonic distortion: 5W / 1KHz / 8 ---- 0.1% 8. Frequency range: 20Hz-20KHz 9. Input impedance: 15K 10. Output Impedance: 4-8 11. Amplifier board size: 30mm * 25mm * 2.5mm 1. The power supply voltage limit is 16.5V, do not use more than this voltage. 2. The power supply is recommended for 12v, 3A power supply filter better 3. 4-8 inch stereo speakers recommended. 4. Do not short-circuit the audio output to each other or shorted to ground. 5. Carefully check before electricity, ensure wiring is correct before electricity.
Rs 212
See product
Pakistan (All cities)
set2: 1 x 600W boost constant current module + 1 x Amplifier Board Small size design, BTL output, the maximum output 100w, can drive 2 ohm speakers, be balanced (differential) input, external heat sink chip work more stable. Signal input mode can be selected according to the following two needs: Balanced input signal (differential): Signal + Signal -, GND (ground). Unbalanced inputs (single-ended): - end and GND (ground) short circuit, the signal input from the + terminal. 3300 / 25V filter capacitor The output voltage regulation: 1. adjust the CV-ADJ potentiometer, according to your or LED, the output voltage is set to the voltage you need. Clockwise voltage is small, counterclockwise adjustable. 2. clockwise CC-ADJ potentiometer about 20 laps, the output current is set to a minimum, connected to the LED, CC-ADJ potentiometer to the required current. For charg, put the after the end of the, then receive the output, adjust the CC-ADJ to the current you need, (for charg must be used when the is fully charged, because the left The more charge, the smaller the charge current.
Rs 3.541
See product